The 2021 KTM 500 EXC-F is a Dual Sport Powerhouse Powered by a 510cc four-stroke single, it develops approximately 58 HP, and more than enough torque for its relatively lightweight frame and body.
When should a dirt bike sprocket be replaced?
The time to replace sprockets isn’t after the teeth are severely curled or worn down to a nub. Or when the chain starts jumping the cogs. To maintain top, reliable performance of your bike and to minimize damage to other components, sprocket replacement should happen long before then.
What holds a sprocket in place?
A set screw is used to prevent axial movement of the sprocket; if one is used, the placing is usually above the keyway. This location keeps the sprocket from moving along the shaft and stops the key from moving. To better hold the sprocket in place, U.S. Tsubaki incorporates two set screws as the standard.
Is front sprocket reverse thread?
If the sprocket is on the left side of the bike, it is standard threaded. If the sprocket is on the right side of the bike, it would be reverse threaded.
Is KTM owned by Kawasaki?
KTM AG (formerly KTM Sportmotorcycle AG) is an Austrian motorcycle and sports car manufacturer owned by Pierer Mobility AG and Indian manufacturer Bajaj Auto. In 2015, KTM sold almost as many street as off-road bikes. Since 2012, KTM has been the largest motorcycle manufacturer in Europe for four consecutive years.
How do I stop my front sprocket from spinning?
The sprocket is not going to quit spinning when you pull in the clutch with no chain. It takes resistance to stop it. Otherwise it will spin no matter what, prob even spin in neutral. Take any scrap chain and just wrap around sprocket and vise grip or wire together.
What kind of sprocket do I need for my KTM 500?
Get a 13 counter shaft sprocket also (cheap) so you can gear it down if you need to. That way you have both options assuming the chain will work with both the 13 and 14 counter shaft sprocket (it should). I run 14/52 have done since my 500 exc 12 and now with my 17.
What’s the torque on a KTM EXC 500?
I run 14/52 have done since my 500 exc 12 and now with my 17. Its a 500 use the torque. Some guys here run a 13/50 but I found that I was always changing gears.
What should the stock ratio be on a sprocket?
Stock was 15/45, 1 tooth to 15/46 was not a lot of change, but you could feel the ratios tighten up slightly, I don’t see me going lower than 15/47, for streetable. My rural backroads are a blend , reaching multiple offroad areas .
How tall is the KTM sprocket M5b in feet?
In all kidding with a new M5B it is a bit tall in third on some hills. However when she’s worn down it is likely right on.? You fatter boy? In all kidding with a new M5B it is a bit tall in third on some hills. However when she’s worn down it is likely right on. [emoji6] 14 x 50 works for me on single track.