What is the default username or password for Cisco sg350?
What is the default username or password for Cisco sg350?
cisco
example, http://192.168.1.254. to use in the web-based interface and enter the username and password. The default username is cisco. The default password is cisco.
What is the default password of Cisco Switch 2960?
When prompted, enter the default password, cisco. username field. The Express Setup window appears.
What is default IP of Cisco switch?
192.168.1.254
The switch uses the factory default IP address of 192.168. 1.254 by default. When the switch is using the factory default IP address, the System LED flashes continuously.
How do I login to a Cisco switch?
Enter the IP address of the switch that you are configuring in the address bar on the browser, and then press Enter. For example, http://192.168.1.254. When the login page appears, choose the language that you prefer to use in the web-based interface and enter the username and password.
What is the default IP for Cisco 2960 switch?
10.0.0.1
The switch has a default IP address “10.0. 0.1” and a secondary IP address “10.0. 0.3”.
What’s the default username and password for Cisco switch?
The default username and password is cisco. Note: The available commands or options may vary depending on the exact model of your device. In this example, the SG350X switch is used.
How to configure password settings on a switch through?
Follow these steps to configure the service password recovery settings on your switch through the CLI: Step 1. Log in to the switch console. The default username and password is cisco. If you have configured a new username or password, enter those credentials instead. Step 2.
How to change default username on Cisco 3560x?
On Catalyst switches, you just have to press the mode button ( showed on Alain’s link ) before starting the switch and keep it until you see the rommon prompt. 02-07-2012 05:22 AM
How to set password complexity in Cisco switch?
The default configuration is 180 days. Follow these steps to configure the password complexity settings on your switch through the CLI: Step 1. Log in to the switch console. The default username and password is cisco. If you have configured a new username or password, enter those credentials instead.