What would cause my dashboard lights to go out?

If the dashboard isn’t lighting up at all, your car might have blown a fuse. Removing the old fuse and replacing it should get the lights working again. If the new fuse doesn’t last long, have it inspected at an authorized Chevrolet service center since you may have a deeper problem in the electrical system.

Is there a fuse for the dashboard lights?

Find the fuse that powers your dashboard lights. Check under the hood, under the dashboard, or near or in the glove compartment. Refer to your owner’s manual if you have trouble locating the fuse boxes or the dashboard light fuse. If you have more than one fuse labeled “lights,” you’ll need to check them all.

What does flashing dashboard lights mean?

Flashes and then stays on: If one of your dash warning lights flashes briefly and then stays on, it means there’s a problem with whatever system that light is tied to. For example, your Check Engine Light might flash and then stay lit if there’s a misfire in the engine, or if one of your oxygen sensors has failed.

Can dashboard lights burn out?

Burned-Out Bulb The dash lights in most modern vehicles are individual LEDs that shouldn’t burn out. However, if you have an older Subaru, the dash may be illuminated by a few incandescent bulbs, instead. If this is the case, a bulb blowing can cause part of the dash lighting to go out.

Why is my dashboard not working?

Start by inspecting the dashboard dimmer switch to see if it was turned down or off. Then, check for a blown fuse or bad lightbulb. If the switch, fuses, and bulbs are not to blame, you likely have a wiring or electrical issue and will need to take your vehicle to a certified mechanic for diagnosis and repairs.

How do I reset my dash gauges?

Insert the ignition key into the ignition lock. Leave it in the 0 or I position. Push and hold the Sel/Reset knob (on the instrument panel by the fuel gauge), or the Sel/reset button on the right hand of the steering wheel below the Multi-Information Display Info button.

How much does it cost to fix dash lights?

On average a mechanic will charge you $951 to replace the dashboard lights in your vehicle.

How do you know if a Cadillac has a warning light?

To diagnose these warning lights, use a Cadillac OBD-II Scanner . The ABS light will come on briefly when the ignition is turned on. Once the engine starts, this light should turn off. Suppose this light comes on while driving; pull over as soon as it is safe to do so.

Where is the diagnostic port on a Cadillac?

The diagnostic port can be found under the dashboard on the driver’s side. For more help, follow our guide on troubleshooting the airbag light on a Cadillac . When this light comes on, that means that the engine has overheated. Pullover as soon as it is safe to do so and turn off the engine.

What does the ABS light on a Cadillac mean?

For more help, follow our guide on troubleshooting ABS light on a Cadillac. When the ignition is turned on, this light shows that it is working but will turn off once it started. It is part of emission control diagnostics. When checking engine light flashes while driving, a misfire has been detected.

What does the IntelliBeam light on my Cadillac mean?

Intellibeam lights are a system that switches between high beam and low beam depending on traffic conditions. When this is light comes, it means auto high beams are activated. This means that the Exterior lamp is only when the DRL (Daytime Running Lights) is active. This comes up when the cruise control system is active.