How do I fix my traction control system?

Turn your vehicle off, then restart it. If the traction control warning light stays off, there was a momentary glitch in the system, and you should be fine to continue. But if the light comes back on and stays on, you should call your mechanic right away and schedule a service appointment.

How do you turn off the traction control on a 2004 Chevy Impala?

How to Disable the Traction Control Sequence on an Impala

Sit in the Impala’s driver side seat. Crank the engine. Inspect the left side of the dash.
Locate the button to disable the traction control. It is between the headlight control switch and the steering wheel.

What does service StabiliTrak mean on a Chevy Impala?

The “Service StabiliTrak Warning” indicates the system is not responding or operating as it should. A failed brake switch will also disable the system as well as the wrong size of tire. The cost of replacing the Impala’s wheel sensor averages $100-$120 in parts and labor.

Is there a fuse for traction control?

On these cars, the dash “TCS” light will come on when you turn the system off. Otherwise, your traction control system might have a separate fuse in the box, which you could pull to disable it. Beware, though — TC systems tend to be integrated with others, like the stability control and anti-lock brakes.

Why is my ABS and traction control light on?

The ABS and Traction Control lights come on whenever the vehicle’s computer or PCM detects a malfunction, a faulty wheel sensor, or other mechanical failures. These warning lights do not imply anything severe by themselves but may point to a graver problem when paired with the main brake light going off.

Can a mechanic fix a 04 Impala traction control light?

I AM NOT A MECHANIC! I WILL NOT BE HELD RESPONSIBLE FOR ANY DAMAGES THAT YOU DO TO YOURSELF AND YOUR CAR IF YOU CHOOSE TO FOLLOW THIS! Here is a small list of things that you will need in order to fix this problem.

What causes a bad connection on an Impala?

That in turn can cause a bad connection to open and close quickly. The computer senses that and turns the light on. The bad connection could be a chafed/broken wire in one of the harnesses to each hub, or it could be one of the connectors going bad at the ends of the harnesses.

How to fix the ABS light on a 04 Impala?

While the lug is unbolted heat up your soldering iron and apply some solder where with lug was crimped onto the wire were the wire is exposed on both sides of the crimp. Put heat shrink tube over this all the way to the end of the crimp where the now soldered wire is showing.

What happens when you release the brake on an Impala?

When you release the brake, if there’s any play in the ball joints or tie rod ends (or strut mounts) the steering knuckle can move a bit causing the wires to flex slightly. That in turn can cause a bad connection to open and close quickly. The computer senses that and turns the light on.